Maybe check with Jake’s? Good chance some internal wiring or fluid circuits were changed for the trans brake which affect what the pressure switch...
You will need some kind of thread sealer on your cutoff AN hose fittings. Those threads are not meant to seal fluid. They just clamp the hose into...
Same thing applies to stud-mounted rockers. I ended up with a 8.15" pushrod vs. the stock 7.8" on my engine. The combination of small base circle,...
Andy, you are correct that the pressure ratios multiply, but they are not the same as they were before boost. After some anlaysis, I realized I...
If the blower is pullied for for 7 psi by itself, it isn't going to be contributing any boost when compounded. Say you're enigne is moving 50...
Go to mcmaster.com and search for 7806K63. Same type of bearing with an 8mm (5/16") bore.
Keep in mind that increasing the boost pressure doesn't necessarily the differential across the jet. If the bowl and venturi inlets are at the...
I have also had this issue. I know for a fact that mine was due to fuel vapors filling the intake piping, displacing the air. After sitting for...
Well you see, they flow so much air, that just sitting around they lift off the ground! I have also heard that sometimes your engine will even...
If you have a parker fittings dealer nearby, ask for an "4-8F50X" which is a -8 O-ring x -4 AN fitting. Priced much lower than aluminum fittings too.
I am using the cloyes cover you mentioned. It is a nice peice, but there were a few casting nubs I had to file down on the mating surface. I am...
I have used cam #2 in a similar combo, and it worked well. It won't have as much low end as cam #1, and you'll need at least a 2500 stall...
Well, with a 8.7:1 cr and that cam, you'd have 7.3:1 dynamic compression ratio, and about 144 psi cranking compression. So, no bottom end. I'm...
Is the 3/8" fitting you're speaking of pipe thread? If it is, it will have ~5/8" id, so no smaller than your hose. I think the problem is too much...
Re: more parts ordered!......(Round 2, skittles)!!! Both the 325/50 and 315/60 have the same tread width of 11". The 325/50 is 28" tall and 13"...