Oops, fat thumbs and typing fast. 3.5 core intercooler with 3" tubing If I remember correctly, I went with a 67mm they offered back then. Can't...
Thanks, I think regardless what route I take it will be going to the dyno. I'll have 5 I have a good turbo setup. It's an old HP Performance...
Thanks, I did check the block and machined the stock heads last time I did the head gaskets. Using ARP bolts torqued to max. My tune should be...
Fuel system is stock with a 355 walbro and 42s.
Thanks for the reply It is my dilemma right now. Dont have the funds/time to build a new engine but I could do a top end. I also need to put...
Hello all, I have a fairly stock 1990 LX. It has an old HP Performance kit on it. Combo has been together for 5 years+. It produces around 380hp...
They could get away with 36ers on a stock 5.0 pushing 350-380. But if you want more then that you want 42s, they should give you enough fuel to...
I read a test in a 5.0 mag where they did back to back runs NT05R vs MTs on a 600hp stang. They gave a very slight edge like a 10th of a sec to...
Dam that sucks, hope the heads and block are alright.
If your looking for 450-500hp max on a stock block, with only 72k on your engine I would go with the BG kit good HGs and some arp studs/bolts. you...
ha ha didnt consider Dazed and Confused a car movie but I have to rate it very highly, awsome movie, kick ass GT0,SS,Duster,trans am and my fav...
Most boosted stangs that Ive seen have a few emissions coming out the breather at idle, unless it is alot of smoke I wouldnt be concerned. Have...
Vanishing Point Bullet Gone in 60 sec Orig(real car crashes 93 in 97min movie) Gone in 60 sec(Eleanor) The original Fast and Furious was good,...
Filling it with oil, past the point where your welding helps to keep the heat down and prevents vapours from igniting. Crankcase vapours can be...