I'm running FRP 80# injectors and good here. I'm using the adapters too and no problems, easy to tune, great idle, etc. I'm unsure of others but...
Is it the higher heat in the exhaust or the back pressure that has you concerned? As for the heat, simply put the cats about as far away as the...
Mcleod would be the best for a twin disc but $1200 is a little steep. I'm running a Spec stage 3...
It could be taken with a grain of salt but from what I understand from some guys at ford over the years is that the nickel content, geometry, and...
If you ordered 4.6 pistons set to be 9.7:1 in a 4.6 then you will be at 9.11:1 in a 5.4 with stock stroke. This will be fine and fairly close to...
Especially considering they are running 2500hp on stock mains.
MMR would be the ones to ask about that. They run 2k+ with the cast caps
Yeah, it seemed crazy the difference in weight. I've never had to deal with such a variance. I had it all rebalanced and finally assembling the...
Is this thing on the road yet??
Yeah, I bought a new block with stock bore and new pistons for that from MMR with total seal rings. I will measure today but I had filed top to...
So I had some off the shelf manley pistons with -11cc dish and a 3.572" bore. I have a new block and purchased the MMR/Manley pistons with -18cc...
Should have included that the pistons were actually making contact with the head. Is there anything else I should look for? The rod and main...
So almost two years ago I was on here about a knocking noise after running my car hard and increasing boost. It seemed that I had compressed...
