I just recently did mine cuz I just didnt like the idea of tapping the oil pan.I ended up removing it drilling it & installing a fitting that way....
how about 2 turbos that came in an eclipse .that would probably be your best bet. Alot of 4 cylinders came turbo. early dodges like...
I dont think half moon sensor is the technical term lol jk :) its actually called a cam synchronizer.
Id say around a 76mm turbo. Im not that familiar with the newer Hemis but stock cams in general are pretty turbo friendly.I agree with Mnlx all of...
A new set of heads are available from Jon Kaase are out called the P38s and they fit the 302/351 SBF. On a pump gas 9 to 1 302,with a modest cam...
Ive searched for this already but nothing came up.Has anyone used Surface gap sparkplugs in an engine with turbo before successfully?how did they...
a 70mm would give u a little room to grow (600hp), but the stock block not so much.the 76mm would be too large unless u add some extra...
yep get yourself the Maf harness,PCM from a mass air Mustang.a Maf preferably a PMAS blow thru.u would be better off with a set of 42lbers, boost...
If i remember correctly they lay the engine back a bit when they do a H22 swap in civics.Wouldnt see a problem with that. u may have a problem...
factory rev limit is 6250.the factory tach is pretty inaccurate
Its not quite in the build stage,I gotta get the mustang done first. I got a 99 4cyl 5sp Jeep Wrangler with a Rubicon 2'' lift on 31s which is far...
Ive been on the board a for a while but finally have the time to start my single turbo mustang project. BTW its a 1991 mustang lx 5.0the fuel...