Thanks guys! Thats what I figured. Will look up the posts by Newaza, appreciate it.
Hey guys. Last year, I turbo'd my 1.8L Miata with an off the shelf kit that included a chinese TO4E T3/T4 copy turbo (journal bearing). Now, I'm...
Thanks for all the suggestions guys! So, I made the channel larger that goes toward the wastegate hole, and also made a little bit of a divot for...
1.) The engine is a 1.8L BP Mazda engine in a Miata. NA, the Miata should make around 130-140 hp. 2.) The downpipe is a 3 inch bellmouth downpipe,...
Thanks! Do you mean something like beveling the inner edge of the wastegate hole? I can also try removing the muffler and see what happens there...
So, I ended up having to buy a new turbo (cheap, chinese T3 turbo) due to overporting the wastegate hole. :( Trying not to do that again, I'm...
I will have to measure the hole and then the gap of the fully open valve and the seat, didn't even think of doing that. Sounds like a good thing...
Hi everyone. I'm having a bit of an issue where I'm having around 4 psi of boost build with my wastegate wired open, whereas the seller of my...
Hi everyone. I just installed the wastegate actuator onto my turbo, and decided to just put some compressed air through it to see if it works. It...
Got it, thanks! I can go ahead and give it a try without a restrictor at first then, and see how it goes.
Thanks! I'll try without the restrictor at first. Is there a length of time I can go without a restrictor before the seals blow? I would probably...
Thanks guys! It seems like the information I get here is a bit different than what I have seen on most turbo miata forums. I would say 95% of...
