With studs and even the factory MLS gaskets, I would be more concerned with the heads cracking/warping than blowing gaskets. Just not enough...
You need to check how much your injector pressure is. If the HPOP is not putting out, it will have low oil pressure on the high pressure side...
Oh and that 20hr figure is for lifting the cab. Its really not as difficult as Ford makes it seem. From what I have seen, a tech that has done a...
Forgot to add that I am driving an 03 F-350 crewcab DRW LWB 4x4 with the 6.0 and auto trans.
I recently installed head studs on my truck. You can do it one at a time, or even remove the heads(there is a thread on powerstroke.org where...
I drive a powerstroke. Truck came with a K&N. After the egr cracked, I completely removed and bypassed the EGR cooler and replaced head gaskets...
Out of all the companies listed, is there a preference on which kit to buy? I am looking into doing a few housings, so it would be to my benefit...
I like these better than jackstands: http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=32052 . This way you can move the car...
This guy is starting to sound like he may be Link's long lost brother or possibly a canadian cousin.
To answer the original question, NO, it is not the answer to your problem. If you read the info on it, you will still have to tell the computer...
What is your fuel pressure set at? You may have to play with it a little bit. Also you can try turning the MAF and try to get it a little better.
This is one time I would refer to stangnet. There is tmoss and a couple other guys there that are very knowledgeable concerning the eecIV wiring,...
Ranger axles are 5 lug. I have a set sitting in my shop. They are also drum. I personally decided to go with the turbo coupe rear end so I can...
Dont the turbo coupes also have 31 spline axles instead of 28? If nobody knows, I guess I can check it out as I have the factory rearend in my car...
I would say either get the gt40s or go for some good aftermarket heads. Do a little shopping and searching and good used heads are to be found. If...