It will rev higher in the burnout. No wires any where around the trans, shifter, or anywhere it can be pinched. Fuel pressure is boost referenced...
I have new car bugs I can't figure out and could use some ideas. My car is a home built Dodge Avenger with a big block Chrysler, PT106, with Fast...
I'm back with an update finally. I was locked out of this forum for a wile. I have a few runs on this thing now. Been to a couple tracks to tweek...
I try'd to put it on the trans break but it needs a little tuning. I will get a log and get on the tune after I button up the loose ends. Here it...
Ha ha ha this thread is old but I finally have some good news. I drove this thing today. Not much but it moves under its own power and sounds...
I'm still working on this thing. It's been a year since I started this post. Time flys when you stick a car on jack stands. I need to get busy on...
I purchased my lot mostly for the property and location but it had 24 units on it already. The new building was about 60k after site prep and 30...
I have storage units. Two buildings with three more plan'd. About fifty units now and after its finished it will be about 150 units. My town is...
Precision just made me a intercooler for my junk. I'm starting to get it plumbed up and make a mount for it. Hope to get it mounted and ready for...
My syncrowave 250 did not come with a plug. I stuck a dryer/range plug on it. It's also on a 50amp breaker
Gents I would like to thank y'all for the help. I stuck a 95 Chevy truck starter on it with no shims and it sounds like butter! Fires up and...
Well after replacing my flywheel it turned over once and sounded ok then the next time a little worse. Then the motor kicked back a little and now...
I will get some knurled bolts tomorrow. That's about the only thing I haven't tryd. Just grade eights now. Yep was A little shocked to see that...
