Re: drawthrough 512" caddy, may convert to blowthrough Just wanted to say if you think the exhast is a restiction then put a pressure gage on the...
Yep, I've seen WAY too many stock GT blocks that look like that with 6-10 psi. Normally the tune was bad. Just because you can't hear or feel...
:chacha: So when is your first Cobra Kill? :angel: -bix
Go with the bigger housing. My twin and I are doing about the same project. Its a mild build 429 in a 71 mustang. BUT we are going with the twin...
You're still running a tad on the lean side. Have you tried to get it down to about 11.5ish throughout the rev range. -bix
Set it low 2-4 psi and run around with it until you get to a dyno and tune it. :2thumbs:. Believe me you don't want to be apart of the blown...
Re: '88 Volvo "740T intercooled" intercooler I love sleepers, you car is quite the sleeper, i think it needs a 100 shot! As for the...
What items are cheaper? What items are cheaper on the 4.6L? Just wondering since Mod motors ARE the wave of the future. I like 5.0L because...
Power... We didn't make BIG power out of the 250, we used a torqer cam with 6ish lbs of boost. That brought up the power to 278rwhp and abou...
Looks Good! I'm suprised everything is looking pretty good, and you are making decent power with 4ish lbs of boost! I still say you need a...
Linc I just noticed that you have a turbo I-6. My brother and i did a 250 I-6 in a 1963 Falcon. Lots of fun a small T4ob with a edlebrock fuel...
My DIY build? Cool, I always knew that water had the biggest latent heat of vaporization and Methanol had the smallest, but methanol had high...
Re: Re: T40B! Humm, so you're saying I didn't look at the picture and think to my self, Gee it looks like a T5-T6 trim compressor ...which...
3 words... Torque to yeild! YEA BABY! er.... No, all bolts stretch and yeild it just depends on your specific combo. -bix
OUCH! Pulled those inserts out like they were nothing! I've done that, but its been under extraordinary circumstances..... anyways good luck -bix