They use oxygenated fuel in Cali, make sure that isnt a factor. Nothing should have changed by just moving from Texas to Cali.
Shortly out of High school, I decided I wanted to build a 390 Ford...... Bought a Core engine, had it bored, Wiseco pistons, stock crank and...
http://www.ebay.com/itm/like/252074975444?ul_noapp=true&chn=ps&lpid=82 I believe the OE kubota's used mitsubishi turbo's. They have wastegates...
How much timing? Timing reduced at MBT? 10-12 psi is safe for the P's with studs. Also make sure your surface finish is good on the deck and heads.
I will never be convinced that those heads ran with out a problem. It WOULD pull in exhaust in that cylinder and cause a misfire. Plenty of...
Make sure your fuel pressure regulator is referenced to boost. Fuel pressure must remain at set point above manifold pressure ( 7psi fuel...
The HP range of the Turbonectics 7868 can be extended a little with a bigger turbine housing. 1.15 or bigger would help it. But, ultimatly the...
ALso worth mentioning., I will assume you are using your MAF in a blow thru manner; Make sure there is at least 8" of straight pipe before the...
I cant speak for the B-cam, but on my F-cam, All I did was raise idle speed and minimum airflow and that was all it needed to idle decent. Make...
What cam do you have?
Using timing table scaled to load and turning OFF all WOT/RPM based timing scalers is best. You really dont want timing on a WOT scale with...
1.6 here
Degreed mine straight up as well. No adjustment needed on the timing set. Pushrods are 7.550" with AFR's and FRPP pedestal rockers.
In my 357w, it has 14" at idle and has a slight lope. They sound A bit rougher in a 302.
The PTE is bigger. I think the MP's are simular in size to the On3's, and I know the PTE is bigger than one of those. I wanted a PTE, but didnt...