These projects are easy to start... but really hard to follow through to completion on. You've done an amazing job, and are an inspiration to...
8.8's are plenty strong. They usually don't fail until wicked fast 60-foot times .. at which point the ring gear usually implodes. I like the...
108mph on a 28 inch tire with 3.73's would mean an enormous amount of converter slip.. depending on where your red line is... if we assume it's...
Cheap ass clamps off Amazon :banana:
Also, made this little bracket that goes into the front seat rear bolts where they protrude through the braced floorboard. There isn't much to...
Then ran the rest of the fuel lines - it's all PTFE. 10an up and back. 8an on the rails. Ran it pretty clean down the frame rail.. through...
Also been going on fuel system stuff. Pulled the intake lid and drilled/tapped/heli-coiled the front of the manifold for the regulator mount....
Haven't quit.. quite the opposite. Wiring stuff and all the little crap I'm doing isn't really sexy to document. Spaced everything on the...
Soooo... the 6530 is still doing the timing and you are just trying to get it running right with the new distributor?? I think the points out to...
I'm a little behind on this one... but you had the Sniper running with no timing control (MSD 6530) ... and are switching over to the dual-sync to...
No worries, my smart-coil kit is Holley's "big wire" deal.. it skips the connector with the main power/ground/ head wires and separates them out...
I've had freeze plugs on a SBF blow out at speed.. not really a fantastic scenario. Tap some new ones in with some gasket maker / right stuff /...
What are the realistic goals for that 300? I'd do something on the smaller side (turbine) as I don't think you're going for mega-power here and...
I'm still over here laughing that you think the passenger side is "a little cozy" for a single. You have more room than just about anything I've...
Also started on the coil harnesses. Cutting them down and shortening them due to my coil mounts (Holley harnesses are built for valve cover...
