After thinking about it long and hard, I decided to re-design the intake plenum design. I was trying to keep it all under the hood. In my view,...
Good point, Tom. I've been thinking the same. I may rethink the shape of the top
Do you see any reason why it wouldn't?
Delete
I'm going to build a buck to hammer form 1/8" thick aluminum sheets around. Hence, the cardboard templates that I will use to build the buck out...
You are going to let the O2 sensor correct the injector pulsewidth as the meth is injected? If so, then I don't think the transition time is going...
At one time I experimented with a plate, not a screen, with many tiny holes drilled through it. The holes were chamfered top and bottom side. That...
Like the stacked screens used on some tig welder torch head designs meant to even out the flow of gas exiting the nozzle.
Do a static test with the injection system, dumping the fuel into a container, not the engine, and measure the weights of the fuels lost from...
So your gasoline system is regulated to say 45 psi during normal running, then when you reach a target boost trigger, the methanol system is...
I think this is it. The flat section at the back will be used to mount the coil pack. [ATTACH] [ATTACH]
Most of the Y plane done. [ATTACH] [ATTACH]
Sounds good, Tom. I'll get more pics up when I've finished setting up the Y plane template
Now to work on the Y plane profile.
OK. Here are a few configurations I've come up with so far. What I want to do is strike the right compromise between design appeal and...
