New to the thread. Not sure what size the turbo is but the turbine housing a/r is 1.32 and the compressor housing is a .60 . I know it is a t4 flange. The comp inducer is 47.60 and the exducer is 70.00. The turbine inducer is 73mm and the exducer is 63mm. Any help would be greatly appreciated. I'm looking for a turbo to remote mount onto a f150 4.6 for a low boost setup.

 

It sounds like a t04b, or e with a p trim turbine wheel. The turbine with a smaller a/r wouldn't be bad for 4.6, but the 47mm compressor is small. Not something that I would run.

 

Your going to want something like a 6765 for that 4.6

 

I will try to post some pics of the turbo later. Would this turbo work for this engine at all I was wanting to run like 4 to 5 lbs maybe make like 300 to 350hp. If not would ther be any way to change the compressor housing and compressor wheel to better fit the engine needs?
Thanks again for the help

 

It looks like a t04b s trim. Even at 300 hp, and 5 psi, your at the edge, or off the map.... not what you want. You can upgrade the compressor, but the 1.32 turbine is not well suited either, and doesn't make sense from a cost stand point.... sell it, and buy something better suited, you'll be much better off.

 

#ad


#ad

 

#ad


#ad

 

#ad


#ad