where are you getting your oil for your turbo feed??? I was going to take it from the fitting on top of the oil filter that Im using for my Oil Pressure Gauge, but thought I would check & see where you gusy are getting it from


this is a GM block with a wet sump for a single 88mm if that matters.

bob

 

I've taken it from the rear (by filter) and at the front drivers side port in the past.

 

x2 (pass side front)

 

is that up @ the top of the motor where the cam is fed from??

thanks
Bob

 

If you are talking about the front it is on the side..low, along the rail.

 

thanks, I will check it out tonight when I get home.

Bob

 

I picked mine up from the drivers side front pan rail down in the front right behind the timing cover.

 

Hey Bob,

I like to come up off the side of the block near the oil filter.
Add a dist block to the end of a couple feet of -6 and plumb
everything from it. Gauge, preussure switch, turbo/s, etc.
At the block add another gauge so while under the hood
tuning you can check oil pressure.

 

Cool idea Robert.

thanks
Bob