PRICE LOWERED
Selling my turbo kit. It's pretty much a copy of the PD kit, with some minor changes. Everything is new or low mileage used. I copied the PD description to help answer any questions you may have. However, Please read my add below carefully so you don't miss any of the mild differences between the PD kit and what I'm selling.

Vehicle 1979-1993 mustang or fox body vehicle
Engine 302 based (8.2 deck) or 351 (9.5 deck) with some changes
Turbo Placement Left to Right
Accessories kept alternator & p/s
Other Must trim 3 spots on passenger side, eliminate the a/c & smog pump & plumbing

"This Pony Down (b series) Stage 3 single turbo kit is a passenger side turbo mounted kit for ease of installation, clean looks, and it allows you to keep the alternator and p/s. But the a/c & smog pump and plumbing to go on the car if it hasn't all ready. Plus with the design of our cold side we can build the kits for fuel injection using a mass air meter (blow through), speed density, or carbed. The horsepower rating of this kit is from as low of 300hp to 1200hp depending on your engine combo and the amount of boost you run. All the specs of this kit is exactly the same as our original stage 3 kit. What we did is just change the location of the way the turbo sits. By doing that it allowed us to run the downpipe under the passenger side header allowing you not to have to take apart the downpipe for plug changes. The only draw back to that was you have to trim a couple of areas on the passenger side for one pipe, one drain hose, and the air filter."

SPECS

Turbo Master Power 70mm
Headers 1 3/4" primary headers, with 1/2" flanges
Crossover 3" with v bands, flex joint
Down pipe- NOT INCLUDED
USED- Wastegate Tial 44mm
USED- Cold Side Piping 3" from the turbo to the throttle body
Silicone all silicone couplers and T Bolt clamps included
VS Racing 50mm BOV
USED- Intercooler Pony Down Stage 3 - air to air (3" in / 3" out) with mounting brackets and hardware
Parker Store -10 drain hose with turbo drain flange
Pipe Coating- Mix of flat black and silver. NOT ceramic coated

MSD/ BTM box.



Model: B503
Shipping Weight: 120lbs
Manufactured by: Pony Down

$2,500 plus PayPal charges/ shipping

Would also trade for a roller Mustang.

Send e-mail to

This content is protected

for pic's.

 

Updated ad.

 

Bump

 

Updated ad- Would trade for a running 79-93 FOX OR a FOX roller needing motor/ trans.

 

You interested in just selling the headers & x-over?

 

No thanks.

 

Bump

 

Price lowered

 

Bump

 

Bump

 

bump

 

bump

 

ttt

 

bump

 

bump