1. The Turbo Forums - The discussion board for both hard core and beginner turbocharged vehicle enthusiasts. Covering everything from stock turbocharger cars, seriously fast drag racers, boats, motorcycles, and daily driver modified turbo cars and trucks.
    To start posting in our forums, and comment on articles and blogs please

    IF YOU ARE AN EXISTING MEMBER: You can retrieve your a password for your account here: click here.

Datalogging with AEM UEGO 1000 wideband

Discussion in 'EFI Tuning Questions and Engine Management' started by BoostedXpectations, Jan 13, 2006.

  1. BoostedXpectations

    Joined:
    Nov 15, 2005
    I'm considering purchasing an AEM UEGO 1000 Wideband o2 system, but have a few questions regarding the datalogging capabilities of it. Does this system have a serial port output, or can it only datalog through an EMS?
    Also, how long do the sensors seem to last during street use? (no race gas)

    Thanks
     
    BoostedXpectations, Jan 13, 2006
    #1

  2. XJared

    Joined:
    Apr 14, 2005
    the gauge type uego and uego controller have a serial output wire that you can datalag to any system with, including the aem ems. ive installed a ton of them and have yet to replace a sensor on a car not using lots of oil and/or race gas :2thumbs:
     
    XJared, Jan 13, 2006
    #2

  3. BoostedXpectations

    Joined:
    Nov 15, 2005
    So with software you can datalog directly to a laptop?
     
    BoostedXpectations, Jan 13, 2006
    #3

  4. XJared

    Joined:
    Apr 14, 2005
    Taken from "Installation Instructions for Gauge-Type UEGO Controller
    30-4111, 30-4112, 30-4121
    30-4211, 30-4212, 30-4221"

    "A serial data stream is also integrated for air fuel (or lambda) ratio output to a RS-232 com port."
    "*BLUE <Serial Output> Connects to a RS-232 com port for hyper-terminal data logging. *"
    "Serial Output The serial output can be used for data logging when an EFI system is not accessible. To run the data stream, a RS-232 (DB-9) Femceptaclee purcha ale Re shall bsed. 14
    Wire View of RS-232 (DB-9) Male Plug wo wires need to be connected to a RS-232 serial port. The BLUE w
    Tire from the AEM EGO Gauge shall be connected to Pin #2 (RX) on the serial port for receiving data. in # 5 (GND) on the serial port shall be grounded. If a standard 9-pin serial cable is to e cut instead, the (RX) wire is typically RED and the (GND) wire is typically GREEN. owever, this should be confirmed with a continuity tester before attempting......."
     
    XJared, Jan 13, 2006
    #4
Loading...
Similar Topics - Datalogging AEM UEGO Forum Date
MPVI Pro datalogging EFI Tuning Questions and Engine Management May 27, 2021
Wiring diag for IAT sensor for datalogging EFI Tuning Questions and Engine Management Feb 17, 2013
Classic FAST datalogging problem EFI Tuning Questions and Engine Management May 10, 2011
Loading...