where should I set this at for the different battery voltages? I searched and found some info for different sized injectors but couldn't find anywhere for 83lb/hr, they are siemens delphi.
Where can I find this info? I have been searching all over.
Thanks.....Don? Shane? please help!!!
here is where it is currently at
opening time in ms 1.63 1.00 .80 .70 .60 .56 .56 .53
battery voltage 8.7v 10.4 12.2 13.9 15.6 17.4 19.1 20.9

 

I have the same 83 lb/hr injectors. Here are my opening times

1.30 1.09 1.00 0.90 0.84 0.81 0.80 0.80
8.7 10.4 12.2 13.9 15.6 17.4 19.2 20.9

 

yeah i figured mine are a little on the low side (a little high ve) I figure you would want to be near 1.0 at normally charged battery voltage 12-12.6volts and probably slightly lower at charging 13.5-14.2volts.
Thanks for posting your numbers.
If anyone else is using 83lb/hr injectors let me know what your injector opening time is so I can also use that for reference or maybe someone else will see this post and chime in.
Thanks again!

 

Who's 83's? Siemens low impedance?

Your quicker values are better then for a BS3 box that seems to have very good injector driver control. Hell, you may even go a little less... maybe 20%

 

Yeah they are siemens low impedence 83lb/hr.
here is how i have them currently set.

opening time 1.63 1.23 1.00 1.00 .97 .90 .80 .54
bat voltage 8.7 10.4 12.2 13.9 15.6 17.4 19.1 20.9

 

you can go down to the .6 region with the injector driver in the BS3. Remember, there is opening time, but there is also closing time so you will have much more fuel flow. I run .60 through most of the cells and my VE tables are very reasonable and pretty darn linear. mid to low 20s at idle and 80-90 up top at 20 psi

 

Won't lowering the opening time require me to increase the ve number in my fuel map? or is it the other way around?