1. The Turbo Forums - The discussion board for both hard core and beginner turbocharged vehicle enthusiasts. Covering everything from stock turbocharger cars, seriously fast drag racers, boats, motorcycles, and daily driver modified turbo cars and trucks.
    To start posting in our forums, and comment on articles and blogs please

    IF YOU ARE AN EXISTING MEMBER: You can retrieve your a password for your account here: click here.

how to measure converter slip with fast xfi 2.0?

Discussion in 'EFI Tuning Questions and Engine Management' started by tt97cobra, Jul 25, 2013.

  1. tt97cobra

    Joined:
    Aug 5, 2009
    What sensors are needed and how is it hooked up to the fast? and where do the sensors need to be? thanks
     
    tt97cobra, Jul 25, 2013
    #1

  2. tt97cobra

    Joined:
    Aug 5, 2009
    Anyone done this?
     
    tt97cobra, Jul 26, 2013
    #2

  3. TurboNova

    Joined:
    Jun 18, 2004
    You will need a driveshaft sensor kit, it mounts on the yoke of the rear end and wires into the VSS connector. However it will only give you slip between the engine and driveshaft. It will not give you exact slip of the converter since the trans can slip a little also.

    You can then do the math engine speed vs driveshaft speed per gear and that will give you a % number.
     
    TurboNova, Jul 26, 2013
    #3

  4. tt97cobra

    Joined:
    Aug 5, 2009
    Ok, where/how do I connect this kit into the fast? Thanks!
     
    tt97cobra, Jul 27, 2013
    #4

  5. TurboNova

    Joined:
    Jun 18, 2004
    Like I said, the VSS connector.
     
    TurboNova, Jul 28, 2013
    #5

  6. tt97cobra

    Joined:
    Aug 5, 2009
    My bad I must have skimmed right over that.
     
    tt97cobra, Jul 28, 2013
    #6
Loading...
Similar Topics - measure converter slip Forum Date
Anybody got an LMA-2 for sale? (LM-1 RPM converter) EFI Tuning Questions and Engine Management Jun 15, 2013
Dual MAF Converter EFI Tuning Questions and Engine Management Dec 28, 2003
Loading...