Hey everyone i am gathering parts as the funds allow. But my major hang up is what Wideband is the best or are there any real difference. The ones that i was looking at are the Aem UEGO and the autometer to match the other gauges in my pod. But anyway is there any real difference between the two. It will only be used only to monitor the air fuel. so i dont know if the Aem has any real advantage.

 

HI, don't know anything about the AEM or Autometer. We use the FJO and have had no problems. The guys we know who use the innovate have had nothing but trouble.

 

i used and liked the Fast/AF meter it is very easy to read while driving,and it will record and play back..

 

I got the AEM for christmas. I use my DFI wideband for data logging but the AEM works nicely for monitering A/F on the street. It's a very easy install also.

 

I have had the same horro story issues with the inovate stuff... I have used the AEM Uego alot, and recommend them to my customers as well...definitely an easy to use product and is worth every penny

 

We're an Innovate seller, but we also use them on our project cars and I've got a DB gauge on my daily driver. They are a bit unforgiving when it comes to grounds and power, but other than that my experience has been they work pretty well and react quite fast. We even found they were able to catch individual cylinder misfires if you looked at the output with an oscilloscope.

 

Nothing but praise for my innovative lc-1 xd16 combo.

Just follow the instructions to a T paying special attention to the grounds.

 

i second this.

 

My buddy has the FAST Dual set up. I wasnt too keen on it because it was hard to read the recorded data when playing it back. However now they have software that you can download and graph the data to make it easier to read and analyse.

 

I run the single Fast meter and love it...yes it plays back at "real time/speed and can be tough to watch...the RPM upgrade kit is the shit.
With the upgrade, it also records an rpm signal and adds it to the display, but it also gives you the option to slow down the play back speed to "1/4 time"

The Fast View software from Fast gives you a dash view, plots a chart for you and you can also export to Excel for a spreadsheet which you can print out and see every o2/rpm sampling point. I use this info to go into my dfi and make changes exactly where needed.

 

I love my techedge!

 

I started with a LC-1 and had nothing but trouble, switched to a AEM and been perfect every since.

 

Are there any issues with the Bosch o2 sensors? Will they work on a 800 rwhp setup? I see guys on ebay pushing the laboratory grade sensors for high heat, high boost applications.

Thoughts?

 

x2 -